1996 MAZDA PROTEGE 4DR SEDAN
Security
Battery BLK + (+) OR WHT/RED IGNITION SWITCH HARNESS
Ignition BLU (+) IGNITION SWITCH HARNESS
Starter01 BLK/BLU (+) + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/WHT(-) (-) DRIVERS KICK PANEL
TrunkTrigger BLU(-) (-) LIGHT IN TRUNK
ParkingLights RED/BLK (+) (+) AT LIGHT SWITCH OR FUSEBOX
Remote Start
Battery BLK + (+) OR WHT/RED IGNITION SWITCH HARNESS
Ignition BLU (+) IGNITION SWITCH HARNESS
Ignition02 BLK/RED + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/RED + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/BLU (+) + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach WHT (-) AT COIL
SpeedSense GRY/RED (AC) ECM CENT.CONSOLE,22 PIN PLUG
ParkingLights RED/BLK (+) (+) AT LIGHT SWITCH OR FUSEBOX
BrakeLights GRN/YEL (+) AT SWITCH
ReverseLights RED/YEL (+) (+) SWITCH ON TRANSAXLE
Horn GRN/ORG (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock WHT/BLU (-) EITHER KICK PANEL ONE WIRE SYSTEM
PowerLock WHT/BLU (-) EITHER KICK PANEL ONE WIRE SYSTEM
LeftFrontWindow01 LF:RED/BLK
RightFrontWindow01 RF:GRN/WHT LR:BLU/BLK RR:RED/GRN
LeftRearWindow01 LF:YEL/WHT
RightRearWindow01 RF:GRAY LR:GRN/BLK RR:WHT/RED
Doorlocks / Windows
PowerLock
USE 4.7KOHM RESISTOR
Convenience
TrunkRelease N/A MANUAL RELEASE
Mobile Audio / Video
Battery BLK + (+) OR WHT/RED IGNITION SWITCH HARNESS
Accessory01 BLK/RED + (+) IGNITION SWITCH HARNESS
Ground BLK/YEL - (-) RADIO HARNESS
Illumination RED/BLK (+) RADIO HARNESS
Dimmer N/A
FrontLeftSpeakerPos BLU/ORG
FrontLeftSpeakerNeg VIO
FrontRightSpeakerPos WHT/VIO
FrontRightSpeakerNeg YELLOW/BLUE
RearLeftSpeakerPos GRN/ORG
RearLeftSpeakerNeg GRN/BLK
RearRightSpeakerPos YEL
RearRightSpeakerNeg ORG
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
